Thursday, 29 May 2014

Body shell fitting and harness check.

Managed to squeeze a morning's work during 1/2 term holiday in which I trimmed the body shell to slot over the roll bar. It will be bolted to the aluminium strips that run along each side of the chassis with 6 screws, 3 each side.

Ugly slots to fit over the roll-bar triangulation will ultimately be
covered by a helmet fairing, although I doubt this will be in place
by the first race!!

Roll bar top clearance looks good for at least 50 mm.
Sure is snug in there!! Probably a little less so for intended
students instead of tubby me!!! harness fits really well and has tons of adjustment.





Still to complete....Battery hatch hinge+catch, drivers headrest, helmet fairing, wiring......the list goes on....

No comments:

Post a Comment

Note: only a member of this blog may post a comment.